How to use

DIRECTION FOR USE

ZAPCAP SAFETY CAP

  1. Rubber must be placed on coloured side of cap with fold over lead tabs facing upwards.
  2. Ensure silicon gasket is fitted and sitting correctly in all grooves.
  3. Place connected male and female plugs into ZAPCAP SAFETY.
  4. Ensure silicone tabs are folded over and surrounding electrical lead.
  5. Close ZAPCAP SAFETY and secure with metal clip.
  6. Put a lock on it and use it for a lock out system.
   
   
ZAPCAP WALL MOUNT
*Before installation, please ensure you are using a DETA3000® power point. If using another brand, confirm with the retailer that it is compatible with the ZapCap Wall Mount.*

  1. Before beginning the installation process, please ensure to turn off the main power at the switchboard.

  2. Open the cover and position the wall mount over the exposed wire. *

  3. Remove the mount and apply silicone adhesive to the back of the frame for a watertight seal.
  4. Strip the wire to expose the three conductors. Fasten the ZapCap wall mount into the wall using screws.

  5. Connect the wires to the power point securely, then screw the outlet into the casing.

  6. Apply Vaseline to the seal around the cap to prolong the life of the seal.

  7. Insert the lead into the outlet for a snug, weather-resistant fit.

  8. For added security, insert a lock into the mount’s lock hole. Follow all safety guidelines during installation.

 

* Please Note: Before marking and drilling, please ensure that the center of the power point aligns with the holes in the gasket.